Brochure

Commercial single-packaged unit
Durability, efficiency, easy installation, trouble-free operationit’s all packed into these compact
units. For maximum flexibility, the convertible airflow design requires no panel cutting, and can
handle most airflow requirements. Gas and electric knockouts are supplied for easy access. And
units can be specified for cooling only, cooling with electric heat, cooling with gas heat or cooling
with a heat pump.
Dual-stage cooling
for maximum comfort
(6.5–12.5 ton units)
Simplicity
®
Control board
with screw connector for
thermostat wiring
Second model nameplate
inside hinged access
panel (standard on all light
commercial products)
Optional disconnect
Base rails with forklift slots
on three sides and lifting holes
on each corner
Optional powered or
non-powered 120 volt GFI
convenience outlet
Common roof curb for all sizes
Easy to clean and access
condenser system
Tool-free door latches
Compressor #2 access
(6.5–12.5 ton units)
Slide-out motor and blower
assembly for easy adjustment
and service
Belt-drive blower motor
Slide-out filter access offering
2" or 4" filters
Solid-core filter drier
Hinged compressor #1 and/or
#2 access
Removable and reversible
drain pan
Bottom- and side-entry power
and control wiring knockouts
Single or two-stage heating
available on 3–5 ton models
Two-stage gas heating
operation standard on
6.512.5 ton models
The big difference: Simplicity
®
Controls
It’s the built-in brain that requires no additional controls.
The Simplicity
®
Control System is part of each Predator
®
model and, for the building manager, it monitors the
entire HVAC system continuously. All alarm and
diagnostic data can be set up and transmitted directly
to an onsite PC. Or, you can monitor the system over
the Internet.
Single-button programming
Five-minute anti-short cycle delay
Alarm recall, even after power failures
Three-minute minimum compressor run time
Built-in low-voltage protection
Independent monitoring of all safety switches