User's Manual

1068152-YTG-L-0815
6 Johnson Controls Unitary Products
F Full Perimeter base rail that fits on many existing curbs
with the stability to withstand an earthquake - This product
was designed with the replacement market in mind which is
why it will fit on many existing curbs in the field but it also takes
into account the new construction market by being versatile and
sturdy. This unit is equipped with heavier gauge and
innovatively designed base rails to prevent damage from
transporting and rigging.
G Coils - All units utilize Micro-Channel "all-aluminum"
condenser coils that provides improved heat transfer
capabilities and reduced refrigerant charge volumes. This
equates to all units meeting LEED EA Credit 4 Requirements
for Enhanced Refrigerant Management. (Make sure to use the
EA 4 Credit 4 Calculator available at UPGnet.com to ensure
that the entire project meets the requirements). MicroChannel
coils are also much easier to clean than your typical fin/tube
designs.
All evaporator coils utilize copper tube with aluminum fin design
for proven reliability and performance.
H Rigid Mounted Blower Assembly - Dynamically balanced
indoor fans ensure better performance and reliability. Large
access panels for easier access, service, and maintenance.
X13 Direct drive (Standard Static Option) and belt drive
(Medium Static and High Static Options) options available on 3-
5 ton products. The belt drive option is standard on 6-12.5 ton
products. Low, Medium, and High Static drive options for airflow
versatility up to 2" ESP with no field installed drive packages
necessary. The X13 motor technology offers several benefits w/
respect to efficiency, operation, comfort, and cost when
compared to other motors. Premium efficiency indoor motors
are standard on ZY06 and ZX14. The IntelliSpeed option is
available on 10 & 12.5 ton products to meet ASHRAE 90.1 and
Title 24 Requirements. The blower section includes a dual
density insulation for indoor air quality.
J Balanced Heating - The two stage gas heating offers
ultimate heating comfort with a balance between 1st and 2nd
stage gas heating. The first stage of a two stage gas heat
option provides approximately 70% of the heating capacity in all
3-12.5 tons two stage gas heat models. Balanced heating
allows the unit to better maintain desired temperatures and
helps saves energy. Low-NOx comes standard with a stainless
steel heat exchanger to meet California environmental
requirements. The heat exchanger section includes foil faced
insulation that is not only environmentally friendly but meets all
NFPA codes.