- Yorkville Music Mixer User Manual

10
Master Sends
Section
25. Mon 1 and
2 Send Masters,
Clip LEDs and Solo
Switches
Mon 1 and 2 Master Sends,
Clip LEDs and Solo switches
are between the summed
channel send signals and
its designated EQ and Send
jack. The Solos and the Clip
LEDs are post-master. Once
again, the main L/R buss is
on Solo when all the other
solos are off.
The Clip LEDs indi-
cate near-overload
conditions. Reduce
the appropriate mas-
ter Mon Send setting
or the channel Mon
send settings to avoid
distortion.
Because the monitor
buss Solo is post-master,
you hear the final mix
through headphones with
the Solo Mode in either AFL
or PFL. Final monitor mix
levels will therefore appear
on the VU-Meter in either
AFL or PFL.
26. Aux Send Master and Clip LED
The Aux Send master is an attenuator between the summed channel Aux sends and the
Aux Send jack. The Clip LED is post-master.
If the Aux Clip LED becomes active, reduce the Aux Send master setting or the chan-
nel Aux send levels to reduce the risk of distortion. Otherwise, set the Aux master as
required for the application - high enough to deliver ample signal strength but not too
high for the connected unit’s input headroom (check the unit’s input clip indicator).
27. Efx 1 and 2 Send Masters and Clip LEDs
These faders are between the channel Efx sends and either the internal effects processor
(Efx 1) or the Efx 2 Send jack (Efx 2). The Clip LEDs are post-fader.
See under Input Channel Features – Efx 1 and 2 Sends for tips about setting up effects.
28. Internal Efx Defeat Footswitch Jack
This regulates internal Efx, Efx 1 and Efx 2. Connect a standard footswitch here (e.g. Apex
model AFS-1) to switch the internal effects on and off.
Aux
Mon
1
Mon
2
Active
Solo
Active
Solo
clip
clip
clip
Aux
Send
Mon 2
Send
Mon 1
Send
0
5
28
7
6
4
3
91
10
0
5
28
7
6
4
3
91
10
0
5
28
7
6
4
3
91
10
0
5
28
7
6
4
3
91
10
0
5
28
7
6
4
3
91
10
0
5
28
7
6
4
3
91
10