Electric Fireplace Instruction Manual Yosemite Home Décor 1-800-305-9872 www.YosemiteHomeDecor.
Quick Reference Guide I. II. III. Prior to installation, please ensure: 1. The rated voltage of your fireplace fits the output voltage of your outlet; 2. The light bulbs in your fireplace are in good condition. To check this, please follow the instructions for replacing the light bulbs on section MAINTENANCE. The heater on your electric fireplace may emit a slight, harmless odor when first used.
IMPORTANT INSTRUCTIONS WARNING You should read and always follow the important instructions below to reduce the risk of fire, electric shock, and injury to persons. 1. Read all instructions before using this fireplace. 2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces, such as surfaces near the heater outlet or light bulbs. The grill directly in front of the fireplace outlet becomes hot during heater operation. If provided, use handles when moving this fireplace.
13. All electrical fireplaces have hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored or where the unit will be exposed to flammable vapours. 14. Do not modify this fireplace. Use it only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. 15. Always plug fireplaces directly into a wall outlet/receptacle.
GROUNDING INSTRUCTIONS This fireplace is for use on 120 volts. The cord has a plug as shown at A in Figure. An adapter as shown at C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available.
INSTALLATION This section provides step-by-step instructions of your fireplace. WARNING The outlet must be 15A/120V. CAUTION Do not remove the four rubber feet at the bottom of the fireplace or install the fireplace directly on soft surfaces, which may restrict air circulation. Otherwise, it may cause a risk of fire or damage. 1.
SET-UP INSTRUCTIONS Most Freestanding fireplace comes completely assembled and wired. Yet, some tools may still be required to prepare the site and assemble some models.
OPERATION This section will explain the function of each convenient control. NOTE The fireplace may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again. • Control Panel Operation A.
B. Operation On the first use of remote controller, install the batteries first: open the battery box by sliding its cover along the arrow, install two AAA batteries according to the marks in the box, and slide the cover to its original position. If no batteries installed or the batteries are not working, the remote controller will be unusable. To use the remote controller effectively, point it to the electric fireplace and keep a distance of 1-5 meters.
MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock to persons or damage. Light Bulb Replacement Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. WARNING Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid burning of skin.
Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.