Installation Guide

OPERATION
This section will explain the function of each convenient control.
NOTE
The heater may emit a slight, harmless odor when first used. This odor is a
caused by initial heating of internal heater parts and will not occur again.
• Control Panel Operation
A. Buttons and indicators
There are four buttons on the remote controller, and four on the control panel of the
each pair of buttons with the same label perform the same function, the back of it is manual switch
near the power cord:
<ON/OFF> button is power switch of the heater;
<DIMMER> button is used to adjust the brightness of simulated flame and logs;
<LOW> bu
tton turns the fireplace insert on and switches it to low
fireplace insert is already working at low
fireplace off.
<HIGH> button turns the fireplace insert on and switches it to high
fireplace is already working at high
fireplace off;
There are four indicators on the control panel:
is the power indicator, it lights up when the
heater is turned off;
indicates the status of the simulated flame and logs.
indicates the heater is working in low
indicates the heater is working in high
The red window on the control panel of
This section will explain the function of each convenient control.
The heater may emit a slight, harmless odor when first used. This odor is a
normal condition
caused by initial heating of internal heater parts and will not occur again.
There are four buttons on the remote controller, and four on the control panel of the
each pair of buttons with the same label perform the same function, the back of it is manual switch
<ON/OFF> button is power switch of the heater;
<DIMMER> button is used to adjust the brightness of simulated flame and logs;
tton turns the fireplace insert on and switches it to low
-
power status.
fireplace insert is already working at low
-
power status, to push this button will turn the
<HIGH> button turns the fireplace insert on and switches it to high
-pow
er status.
fireplace is already working at high
-
power status, to push this button will turn the
There are four indicators on the control panel:
is the power indicator, it lights up when the
heater
is working, and turned out when
indicates the status of the simulated flame and logs.
indicates the heater is working in low
-power status;
indicates the heater is working in high
-power status.
The red window on the control panel of
heater
is the eye of receiver, do not cover.
9 | P a g e
normal condition
There are four buttons on the remote controller, and four on the control panel of the
fireplace insert,
each pair of buttons with the same label perform the same function, the back of it is manual switch
<DIMMER> button is used to adjust the brightness of simulated flame and logs;
power status.
If the
power status, to push this button will turn the
er status.
If the
power status, to push this button will turn the
is working, and turned out when
the
is the eye of receiver, do not cover.