Installation Guide

10 | P a g e
B. Operation
On the first use of remote controller, install the batteries first: open the battery box by sliding its
cover along the arrow, install two AAA batteries according to the marks in the box, and slide the
cover to its original position. If no batteries installed or the batteries are not working, the
remote controller will be unusable.
To use the remote controller effectively, point it to the electric fireplace and keep a distance of
1-5 meters.
There are four buttons marked the same as buttons on the remote controller, each pair of them
perform the same function, choose as you favor.
1. On/Off Switch . Press on/off switch to turn fire on. The indicator lamp will brighten
up in the control panel. Press the <ON/OFF> button again; the fireplace insert will be
powered off.
2. Flame Effect Dimmer . Adjust the brightness of simulated flame and logs. When the
fireplace insert is powered on, flame is turned on automatically. Press <DIMMER> button
to adjust the brightness, the lamp will be flashing. During the dimming cycle the fire
will slowly dim then brighten allowing user to choose suitable level. Press a second time
to stop cycle when the desired brightness level is obtained.
3. Heater Low Heat (750 W). Press <LOW> button once to switch the fireplace insert to
low-power status. The indicator lamp will brighten up. Press again the <LOW> button
to turn it off.
4. Heater High Heat (1500 W). Press <HIGH> button once to switch the fireplace insert to
high-power status. The indicator lamp will brighten up. Press again the <HIGH>
button will turn it off.
NOTE
Before the heater emits heat or after it stops producing heat, the hot air outlet may output air
for 10 seconds. This is designed to protect the circuit.
6. Switch off the heater when you leave it for a long time.
7. Remove the two alkaline batteries from the appliance before it is scrapped.
8. The alkaline batteries need to be disposed of safely.
9. Roll up the power cord in the supports when the fireplace is not in use. If you select to
store your heater fully assembled, be sure to cover it, to protect it from accumulating dust.
10. Temperature Limiting control will automatically turn the unit off if it reaches a certain
temperature. Unplug the unit. When the temperature falls, the thermostat will be
restored. Connect the plug to power and heater will work.