Installation Guide

5 | P a g e
INSTALLATION
This section provides step-by-step instructions for installation of your fireplace insert.
Site Selection
Review and consider all of the following conditions for installation:
• Dimensions of the unit
• Unit requires a minimum of two (2) wall studs in order to ensure a secure installation.
The fireplace insert comes completely assembled and wired. Some tools may be required to prepare
the site and assembly/install the trim. It can be installed to:
• Existing Fireplace
• Custom Mantel Surround
• Wall Construction
WARNING
The outlet must be 15A/120V. If there is no 15A/120V outlet near the desired location, install
a new one.
CAUTION
Do not remove the four rubber feet at the bottom of the heater or install the heater directly on
soft surfaces, which may restrict air circulation. Otherwise, it may cause a risk of fire or
damage.
NOTE
It is a good idea to place your fireplace insert near an existing outlet, for ease of electrical
hook up.
WARNING
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric
shock or injury to persons, always use a licensed electrician.