User's Guide

F-2. Unpairing
At the Vibraon Sensor (controller),
press and hold the SET buon for
10-15 seconds unl the LED quickly
blinks green, then red, then, release
the buon
1
At the YoLink Relay (responder), press
and hold the POWER buon for 10-15
seconds, unl the LED quickly blinks
green, then red, then, release the
buon
2
c. SET Buon
(10-15
seconds)
U p o n u n - p a i r i n g , t h e V i b r a  o n
Se n s o r L E D w i l l st o p b l i n ki n g a n d
t u r n o ff, a n d th e YoL i n k Re l ay LE D
w i l l st o p b l i n k i n g a n d ret u r n to th e
p r e v i o u s c o l o r ( gre e n fo r t ur n e d
o n , re d fo r t u r n e d off )
3
The YoLink Relay will no longer respond
when the vibraon is detected
4
b. Turn on
the relay
a. SET Buon
(10-15 seconds)
22