Product Warranty

goods to Buyer, Buyer's representative or common carrier.
TAXES: The amount of any sales, excise or other taxes, if any, applicable to the products shall be added to the purchase
price and shall be paid by Buyer unless Buyer provides Seller with an exemption certificate acceptable to the taxing
authorities. Any taxes which Seller may be required to pay or collect under any existing or future law, upo
n or with respect to
the sale, purchase, delivery, storage, processing, use or consumption of any of the products, including taxes upon or
measured by the receipts from the sale thereof, shall be for the account of the Buyer, who shall promptly pay the amount
thereof to Seller upon demand.
SEVERABILITY: These terms and conditions of sale shall not be construed against the party preparing them, but shall be
construed as if all parties jointly prepared these terms and conditions of sale and any uncertainty or ambiguity shall not be
interpreted against any one party. If any provision hereof is held to be illegal, invalid or unenforceable under any present or
future laws, such provision shall be fully severable and the terms and conditions herein shall be const
rued and enforced as if
such illegal, invalid or unenforceable provision had never been made a part hereof. The remaining provisions herein shall
remain in full force and effect and shall not be affected by such illegal, invalid or unenforceable provisions or by their
severance herefrom.
SET-OFF: Buyer shall not be entitled to set-off any amounts due Buyer against any amount due Seller in connection with
this transaction.
CERTIFICATIONS: Seller certifies that it does not and will not maintain or provide f
or its employees any segregated facilities
at any of its establishments and that it does not permit and will not permit its employees to perform their services at any
location, under its control, where segregated facilities are maintained. Seller certifies further that its services are performed
in compliance with the Fair Labor Standards Act of 1938, as amended.
WARNINGS:
Misuse of vises can cause serious injury to eyes, hands and or other body parts. Vises must be set up and used properly.
Before setup and use, read, understand and follow all instructions outlined below.
Always make sure bench tops are properly
secured.
Always use proper nuts, bolts and lock washers in
all mounting holes, to hold bench vise
down.
Always use vise of proper size and capacity to hold
work object.
Always wear eye, face and ear protection when
striking or using power tools with a vise.
Always wear dust mask or respirator when working
with wood, metal, chemical dusts or mists.
Always wear restrictive hair covering and anti slip
footwear while operating vise.
Always hand tighten handles of lockdowns for
swivel base.
Always inspect vise for stress fatigue or damage to
the vise before using.
Always maintain the vise – grease main screw
regularly.
Always make sure castings are firmly mounted to
the work surface, NO GAPS.
Never use a hammer, extension pipe, or cheater bar
on spindle handle of vise.
Never exceed the maximum applied torque of the
vise.
Never unscrew movable jaw beyond maximum
specified opening of vise.
Never weld base of vise to any metal object.
Never use a vise to press an object into or out of
another object.
Never use and extension pipe to tighten handles of
lockdowns.
Never place pressurized containers or combustible
materials in vise.
Never wear loose clothing or jewelry while operating
vise.
Never apply extreme heat or prolong heat to the vise
as it may alter structural properties
Never tighten work piece at the edge (top or side) of
the vise as this may break vise casting.