Operator's Manual

Operator Manual – Prodigy Sleep System
Revision: 04; CCRF-625
Effective Date: 30-Jan-19
Document Number: YST-UDoc-PR2-001-04
30 of 61
 Setup the Prodigy Sleep System in front of a mirror.
 It is recommended that you wear a thin t-shirt or pajama top along with loose pants/shorts.
 It should take approximately 30 minutes to apply the equipment.
Important setup information:
 Application of the equipment will be in the following order:
1. Prodigy CMU 2. Prodigy HMU 3. Nasal Cannula 4. Pulse Oximeter
 Use of the TTU will begin after you have applied the equipment.
 Do not remove the paper/plastic backings ofthe sensor pads until the cable leads are connected
and you are ready to apply each sensor pad to the skin.
 Prior to applying each sensor pad to your skin, use the provided alcohol swabs to wipe clean the
area. Allow 30 seconds for the area to dry before applying the sensor.
SECTION 1: PRODIGY CMU SETUP
Components needed:
Prodigy CMU
Effort Belts (2x)
Dual Connector Effort Belt
Cables (2x)
Dual Snap Lead Cables for
Legs (2x)
Dual Snap Sensor Pads for
Legs (2x)
Single Snap Lead Cables for
Chest (5x)
Single Snap Sensor Pads for
Chest (5x)
Alcohol Swabs & Medical
Tape
Step 1: Apply the leg sensors.
→ There is one dual snap sensor pad for each leg.
→ Connect a dual snap lead cable to each dual snap sensor pad. Colours can be
connected in any order.
→ Remove clear plastic backing and apply sensor pad to the cleaned area on each leg,
ensuring it is not applied to the shin bone.
→ Run unconnected end of each cable underneath your pant/short legs.
UNCONTROLLED COPY - SGS - 30-JAN-19