Operator's Manual
Table Of Contents
- Warning, Caution, and Note Statements
- 1. Introduction
- 2. System Overview
- 3. Instructions for Use
- 4. User Setup
- 5. Re-Processing
- 6. Troubleshooting
- 7. Technical Description
- 8. Appendices
Operator Manual – Prodigy Sleep System
Revision: 04; CCRF-625
Effective Date: 30-Jan-19
Document Number: YST-UDoc-PR2-001-04
33 of 61
SECTION 2: PRODIGY HMU SETUP
Components needed:
Prodigy HMU
Dual Snap Sensor Pad
(1x)
Single Snap Sensor
Pads (2x)
Wired Sensor Pads
(4x)
Alcohol Swabs &
Medical Tape
Step 1: Connect the snap sensor pads to the Prodigy HMU.
→ Without removing the clear plastic backings, connect the dual snap sensor
pad and two single snap sensor pads to the HMU.
Step 2: Connect the wired sensor pads to the Prodigy HMU.
→ Match and insert coloured connectors of the wired sensor pads to HMU.
(be sure to connect the wire connectors into the colour matched input on
the HMU)
→ Push the connectors firmly into the HMU.
Step 3: Adhere the Prodigy HMU to your forehead.
→ Remove the plastic backing off of the dual and single snap sensor pads without
touching the sensor gel.
→ Before applying to your skin, center the HMU on your forehead with the
bottom of the device aligned with your eyebrows as shown below.
→ Adjust the left and right single snap sensor pads to avoid your hairline.
→ Press the HMU firmly against your forehead and hold for five seconds.
→ Secure the left and right single snap sensor pads to your forehead by rubbing
the outer edges with your finger as shown below.
Step 4: Apply the wired sensor pads.
→ Remove clear plastic backing of the wired sensor pad without touching the sensor gel.
→ Secure each sensor pad to the areas as shown below by rubbing the outer edge
→ Replace any sensors which fail to adhere and use medical tape to secure any loose wires.
UNCONTROLLED COPY - SGS - 30-JAN-19