Instruction Manual

System 182 Installation
3 - 9
ba76024e01 02/2012
3.4.3 Variant 2: stack expansion backwards
Preparing the stack
mounting
Fig. 3-6 Preparing the MIQ modules for stack mounting (variant 2)
Mounting the contact
base
Fig. 3-7 Mounting the contact base (variant 2)
1 Remove the covers from the drilled mounting holes (pos. 1 and
3 in Fig. 3-6).
2 Remove the contact cover (pos. 2).
3 Pull off the adhesive label (pos. 4).
4 On the MIQ module, remove the two countersunk screws (pos.
5) and swing open the module lid.
5
13
24
For stack mounting remove label
and install contact carrier
3
4
MIQ module DIQ/S 182-PR
6
7
DIQ/S 182-PR