Owner's manual

PROFIBUS connection System 182 XT-4
7 - 2
ba76027e01 02/2012
 Have admissible bus parameters been set only? If you are in doubt
set them to default values.
 Is it guaranteed that the PROFIBUS master has consistent access
to the 16 byte sensor data structure?
Note for Siemens PLC with programming language STEP7:
The following commands have to be used for consistent access:
– SFC15 (for writing)
– SFC14 (for reading)
 After commissioning:
Do all devices signal error-free behavior?
(DIQ/S 182 XT-4-PR: status "Online" in the measured value and
status display).