Yuga CLM920 TD5 LTE Module Hardware Manual
Table Of Contents
- 1 Introduction
- 2 Product Overview
- 2.1 General Description
- 2.2 Key Features
- 2.3 Module Function
- 3 Application Interface
- 3.1 General Description
- 3.2 Module Interface
- 3.2.1 52-pin Goldfinger
- 3.2.2 Interface definition
- 3.3 Power Interface
- 3.3.1 Power Design
- 3.3.2 Reference Design of Power Supply
- 3.3.3 VDD_EXT 1V8 output
- 3.4 Reset mode
- 3.4.1 Power-on sequence
- 3.4.2 Power off
- 3.4.3 Reset control
- 3.5 USB interface
- 3.6 UART interface
- 3.7 USIM interface
- 3.7.1 USIM card reference circuit
- 3.7.2 UIM_DET Hot-Plug Reference Design
- 3.8 General purpose GPIO interface
- 3.9 Network Indication Interface
- 3.10 Analog voice interface
- 3.10.1 Analog Voice Reference Design
- 3.10.2 Analog Voice Reference Design
- 3.11 PCM audio interface
- 3.12 Antenna Interface
- 3.12.1 RF Connector Location
- 3.12.2 RF Connector
- 4 Overall Technical Indicators
- 4.1 Overview of this chapter
- 4.2 Operating frequency
- 4.3 Conducted RF Measurements radio frequency
- 4.3.1 Test environment
- 4.3.2 Test standards
- 4.4 Conducted receive sensitivity and transmit pow
- 4.5 Antenna requirements
- 4.6 Power consumption characteristics
- 5 Interface electrical characteristics
- 5.1 Operating Storage Temperature
- 5.2 Module IO electrical characteristics
- 5.3 Power supply characteristics
- 5.4 Electrostatic characteristics
- 6 Structural and mechanical properties
- 6.1 Appearance
- 6.2 Mini PCI Express connector
- 6.3 Module fixing method
CLM920_TD5 LTE Module Hardware Manual
8
域格信息技术有限公司
YuGe Information Technology Co.,Ltd
2.2 Key Features
Table 2- 1 Operating frequency band
Network
Band
Product Series
CLM920_TD5
GSM
GSM850
GSM900
GSM1800
GSM1900
LTE(FDD)
LTE FDD B1
LTE FDD B2
LTE FDD B3
LTE FDD B4
LTE FDD B5
LTE FDD B7
LTE FDD B8
LTE FDD B17
LTE FDD B20
LTE FDD B28
LTE(TDD)
LTE TDD B38
LTE TDD B39
LTE TDD B40
LTE TDD B41
TD-SCDMA
TD-SCDMA B34
TD-SCDMA B39
WCDMA
BAND 1
BAND 2
BAND 5
BAND 8
CDMA2000/EVDO
BC0
optional
GNSS
GLONASS
GPS
BeiDou/Compass
Category 1
① GNSS function is optional.
② The module supports Category 4 as default. The module label will notes CAT 1
when it supports Category 1. CAT1 doesn’t support diversity.