Yuga NB module hardware manual V1.01
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Review of modules
- Chapter 3. Interface application description
- Chapter 4. RF overall technical index
- Chapter 5. Electrical characteristics of interface
- Chapter 6. Structure and mechanical properties
- Chapter 7. Production and packaging
- Chapter 8. Terminology abbreviation
LPM2100 mg NB module hardware manual
Shang Hai YUGE Information Technology co., LTD
Page
29
of
39
Figure 4-3 complete structure of microstrip line
Figure 4-4 reference to the structure of the third layer microstrip transmission line
Figure 4-5 complete structure of strip line
4.4 Radiofrequency connector
In the design process, if the RF connector is required, the antenna connector must use a
50 ohm characteristic impedance coaxial connector, and the Hirose UF.L-R-SMT connector is
recommended.