V11172015
TABLE OF CONTENTS 01 01 02 03 03 04 04 INTRODUCTION SPECIFICATIONS GENERAL WARNINGS SAFETY PRECAUTIONS OVERVIEW SD CARD INSTALLATION LED STATUS INDICATION AERIAL IMAGING SYSTEM 05 05 06 07 07 08 09 09 10 11 11 11 11 12 ATTACHING CGO4 GIMBAL CAMERA TO MULTI-COPTER BINDING CGO4 GIMBAL CAMERA TO THE ST24 (SINGLE MODE) CAMERA CONTROL ON MULTI-COPTER(SINGLE MODE) BINDING CGO4 GIMBAL CAMERA TO THE ST24 (TEAM MODE) BINDING H920 MULTI-COPTER TO THE ST12 (TEAM MODE) CAMERA CONTROL ON MULTI-COPTER (TEAM MODE) CGO4
INTRODUCTION The TORNADO ProAction™ is a ground imaging system designed to extend your Panasonic® camera GH4 and SONY® α7 with real-time imaging transmission. The system includes the ProAction™ ground handle and GB603 gimbal. The ProAction™ features pitch controller, allowing for precise camera angle control. The GB603 gimbal, 3-Axis self-stabilizing gimbal, enables you to capture smooth and fluent photographs and video footage.
GENERAL WARNINGS IMPORTANT NOTE: All safety precautions and warnings, instructions, warranties and other collateral information is subject to change at the sole discretion of Yuneec. For the most up-to-date information please visit the corresponding product page at www.Yuneec.com or contact the nearest Yuneec office or authorized distributor.
SAFETY PRECAUTIONS PROACTION Do not touch or move the ProAction within about 12s until the initialization is completed. Do not operate the ProAction in the rain! Do not expose the ProAction to fire sources! The ProAction can't be operated after the second level low voltage battery warning! CGO4 Do not expose the CGO4 gimbal camera to water. Do not expose the CGO4 gimbal camera to rain, moisture, dripping or splashing. Do not expose the lens of the CGO4 gimbal camera to excessive light sources.
SD CARD INSTALLATION NOTICE: Before photo-taking, SD card should be fully inserted into the camera. (The SD card is not included in the package.) CAUTION: Power off the camera before inserting or removing the card. STEP 1): Remove the rubber bumpers. STEP 2): Slide the memory card into the card slot in accordance with the direction indicated by the sticker. STEP 3): When fully inserted, the card clicks into place.
AERIAL IMAGING SOLUTION ATTACHING CGO4 GIMBAL CAMERA TO MULTICOPTER STEP 1): Mount the Rubber Dumpers to H920 fixing eyelet, install the two thread-off proof screws to fix the gimbal damping plate and then tighten all the screws.
NOTICE: We recommend users to power on the aircraft in the angle mode. NOTICE: When returns back to the FPV interface, you will hear two long beeps. That means the binding is complete. The Real-time images can now be seen on the screen. CAMERA CONTROL ON MULTICOPTRER (SINGLE MODE) CAUTION: The gimbal can only be controlled through ST24 When being attached to H920. Gimbal Pitch Control Gimbal Pitch Control There is a gimbal pitch mode switch on ST24---S1.
BINDING CGO4 GIMBAL CAMERA TO THE ST24 (TEAM MODE) STEP 1): Power on the ST24, tap [ ] to go to the main interface. STEP 2): Switch on the TORNADO H920. Wait until the gimbal LED blinks green. That means the Wi-Fi has been started up. STEP 3): Tap System Settings icon to enter the Bind interface. STEP 4): Tap the Refresh icon, and the code of the Aircraft Model (it indicates the code of the CGO4 receiver) and Camera will both be shown on the screen. Select the right codes and tap the Bind icon.
] twice to return to the main screen and the model /receiver should automatSTEP 8): Tap [ ically connect to ST12 NOTICE: The H920 main LED indicator will blink red and white if the TORNADO loses GPS signal /lock. The H920 main LED indicator will be solid color of the current mode if the GPS signal/lock is acquired. CAMERA CONTROL ON MULTICOPTER (TEAM MODE) GIMBAL PITCH CONTROL There is a gimbal pitch mode switch on ST24---S1. When the switch is in up/middle position, the gimbal camera is in Angle Mode.
CGO4 INTERFACE (ST24) MODE N/A STD 9:43:31 pm Welcome, Pilot Model: H920 CGO4 4K 30 p AFS 4:3 VOLTS H N/AV GPS ALT N/A N/Am SAT G-SPD N/A N/A KPH POS DIS N/A E N/A N N/A m On 00:00:00 01 MODE P System Settings 02 F3.5 1/60s -2/3 ISO 200 WB Model Select Channel Settings 03 04 05 06 07 01. CAMERA SWITCH 02. CAMERA MODE 03. WHITE BALANCE 04. ISO SENSITIVITY 05. EXPOSURE VALUE 06. APERTURE/SHUTTER SPEED 07.
CAMERA MODE INTRODUCTION The CGO4 gimbal camera has eight camera modes in total,providing photographers with a multiple of choices for different shooting scenes. INTELLIGENT AUTO MODE: The subjects are recorded using settings automatically selected by the camera. NOTE: In this mode, the camera makes the optimal settings for the subject and scene, so we recommend it when you wish to leave the settings to the camera and record without thinking about them.
ADJUSTING THE WHITE BALANCE In sunlight, under incandescent lights or in other such conditions where the color of white takes on a reddish or bluish tinge, this item adjusts to the color of white which is closest to what is seen by the eye in accordance with light source.
Mechanical Shutter Speed [Still image] Bulb(Max. 60minutes),1/8000-60 [Motion picture]: 59.94Hz: 1/16,ooo-1/30; 50.00Hz: 1/16,ooo-1/25; 23.98Hz: 1/16,ooo-1/24 Shutter Life Approx.
PHOTO STYLE This selects effects to match the type of image you wish to record and adjust the color and image quality of the effects.(Standard / Vivid / Natural / Monochrome / Scenery / Portrait) ASPECT RATIO This allows you to select the aspect ratio of the pictures to suit printing or the playback method. 4:3 [Aspect Ratio] of a 4:3 TV 4608x3456 (16M) ; 3264X2448 (8M); 2336X1752 (4M) 3:2 [Aspect Ratio] of a 35mm film camera 4608X3072 (14M); 3264X2176 (7M); 2336X1560 (3.
PHOTO STYLE You can select effects to match the type of image you wish to record. You can adjust the color and image quality of the effects. STANDARD / VIVID / NATURAL / MONOCHROME / SCENERY / PORTRAIT DRIVE MODE Slide the menu and select Drive Mode. A menu will pop up with two menu items: Normal, Burst for the photographer to select with. NORMAL When the shutter button is pressed, only one picture is recorded.
GROUND IMAGING SOLUTION APP DOWNLOADING Download the free APP named CGO4 to smart device at the APP Store or Google Play Store. Install the APP to your 5.8GHz Wi-Fi capable device. Make a note of the network name and password located on the top of the gimbal assembly. CGO4 APP COMPATIBLE DEVICES: APPLE IOS: IOS 7.0 or above ANDROID: Android 4.
When the self-check (start-up) process is complete, the Control Status LED will grow solid blue. The user can switch freely between Follow Mode and Global Mode without powering off the gimbal. FOLLOW MODE In Follow Mode, the camera lens moves in the direction of ProAction. The user can only manipulate the pitch direction through Gimbal Control Stick on the right. If the Gimbal Control Stick moves upward, the camera lens will trim itself up.
SINGLE HAND OPERATING: Lift the center carrying handle with one hand. When holding the ProAction™ with single hand, press and hold the Function Switch Button in the rear of the Pitch Control Wheel. The Control Status Indicator will glow solid blue when successfully switched. The control right has been switched to the Pitch Control Wheel on the center carrying handle. The Gimbal Control Stick on the right side of the ProAction™ is disabled in Pitch direction.
APP INTERFACE A STD 4K 30p AWB AFS 4:3 Len: EV: YUNEEC_81004F F: SS: 16: 55: 08 05 06 01 02 07 03 08 09 04 5739 pic 10 01. WHITE BALANCE 02. EXPOSURE VALUE/ISO SENSITIVITY 03. APERTURE/SHUTTER SPEED 04. FULL SCREEN DISPLAY 05. FOCAL LENGTH 06. CONTROL MENU 07. VIDEO-RECORDING 08. BUTTONPHOTO-TAKING BUTTON 09. LEFT STORAGE 10. SETTING MENU PHOTO TAKING AND VIDEO RECORDING TO TAKE PHOTOS STEP 1): Tap the APP icon on your mobile device and you’ll come to the Camera Control Interface.
CAMERA MODE INTRODUCTION The CGO4 gimbal camera has eight camera modes in total,providing photographers with a multiple of choices for different shooting scenes. INTELLIGENT AUTO MODE: The subjects are recorded using settings automatically selected by the camera. NOTE: In this mode, the camera makes the optimal settings for the subject and scene, so we recommend it when you wish to leave the settings to the camera and record without thinking about them.
AWB Daylight Cloudy Shade Halogon AWB: Automatic Adjustment Daylight: When taking pictures outdoors under a clear sky Cloudy: When taking pictures under a cloudy sky Shade: When taking pictures outdoors in the shade Halogon: When taking pictures under the incandescent lights NOTICE: It will operate as [AWB] during motion picture recording. SETTING THE LIGHT SENSITIVITY This allows the sensitivity to light (ISO sensitivity) to be set.
When CGO4 gimbal camera is in Manual Exposure Mode: the photographer can determine First, tap Mode button on the lower portion of the screen and a virtual mode dial will pop up on the screen and then set the mode dial to [M].Slide the aperture value picker and shutter speed picker to set the appropriate aperture value and shutter speed.
VIDEO ENCODING This allows you to set different video formats. MP4 The MP4 data format is suitable for playback on a PC, etc. MP4(LPCM) The MP4 data format for image editing MOV Data format for image editing. VIDEO QUALITY This sets up the picture quality for motion pictures: OPTIONS: MP4 30P 100Mbps 4K; MP4 24P 100Mbps 4K; MP4 60P 28Mbps 4K; MP4 30P 20M IMAGE SIZE This sets the number of pixels.
AF MODE This allows the focusing method that suits the positions and number of the subjects to be selected. Focus and exposure will keep on following the subject even if it moves. 1-Area: The camera focuses on the subject in the AF area on the center of the screen.Position and Size of the AF area can be changed. 49 point: Up to 49 AF areas can be focused.This is effective when a subject is not in the center of the screen.You can select areas to be in focus.
DISCLAIMER Yuneec Electric Aviation cannot be held liable for any damage, injury or for use of the product in violation with legal regulations, especially in the following circumstances: Damage and/or injury as well violation of legal regulations resulting from a failure to comply with the operating instructions or the instructions at www.yuneec.com, product information, user manual and other legally binding information.
Further losses which do not fall within the scope of use defined by Yuneec Electric Aviation as improper. This product is designed for both professional use and personal, private use. The national and international laws and regulations in force as the time of taking off must be adhered to.
Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IC Radiation Exposure Statement for Canada This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.