User's Manual

dot next to the me length of the recording near the upper right-hand
corner on the screen of the ST10+.
TAKING PHOTOS AND RECORDING VIDEO
The ST10+ seamlessly integrates control of the CGO2+ so you can easily
take sll photos and start/stop video recording using the corresponding
buons located on top:
TO TAKE A STILL PHOTO
TO START/STOP RECORDING VIDEO
Press the buon located near the top
right corner of the ST10+. You’ll hear an
audible indicaon from the ST10+ each
me the recording starts/stops. And
while video is recording the LED indica-
tor on the front of the CGO2+ will flash
blue and green, and there will be a red
Press the buon located near the top
le corner of the ST10+. You’ll hear an
audible ‘shuer’ sound from the
ST10+ and the LED indicator on the
front of the CGO2+ will change from
glowing solid green to glowing solid
blue. It will take approximately 5
seconds to capture the photo and before you can take another sll photo.
IMPORTANT NOTE: You cannot take sll photos while recording video.
You MUST stop recording video in order to take sll photos.
IMPORTANT NOTE: You can choose to record video at 48, 50 (PAL) or 60
(NTSC) frames per second by tapping the corresponding buon near the
upper le-hand corner on the screen of the ST10+. And keep in mind that
the delay in the live video stream will be lowest at 48 and 50 as compared
to 60 frames per second.
The slider located on the le side of the ST10+ allows you to set the
pitch/lt posion of the CGO2+ from approximately straight ahead (when
the slider is in the uppermost posion) to approximately straight down
(when the slider is in the lowermost posion). And you can easily set a
posion in between by adjusng the slider accordingly.
QUICK TIP: There’s an adjustable counterbalance located on the rear of
the CGO2+. This counterbalance has been adjusted at the factory to
provide the best balance and performance overall so typically it should
NOT need to be adjusted. However, if you find that the CGO2+ is making
any ‘buzzing’ sounds while powered on, carefully twist the counterbalance
in or out unl the sound stops in order to achieve the best balance, perfor-
mance and photo/video quality.
4