Users Manual

Gimbal Control
GIMBAL C AMERA TILT C ONTROL
There is a gimbal tilt mode switch on ST16E. When the switch is in up/middle position, the gimbal
camera is in Tilt Angle Mode. Use the Gimbal Tilt Control Slider on the left side of the ST16 to set
the tilt position of the gimbal camera.
When the Switch is in bottom position, the gimbal camera is in Velocity Mode. When the Gimbal
Tilt Control Slider is in the middle position, it means the Tilt velocity rate is 0 for the gimbal, and it
will stop tilting up/down
When the Gimbal Tilt Control Slider is above the middle position, the gimbal will start tilting up.
When the Gimbal Tilt Control Slider is below the middle position, the gimbal will start tilting
down. The distance between the Gimbal Tilt Control Slider and the middle position decides the
velocity rate, the further distance, the higher velocity it would be.
GIMBAL C AMERA PAN C ONTROL
There is a gimbal pan mode switch on ST16E. When the switch position is up, the gimbal camera
is in Follow Mode. The pan control of the gimbal camera is now disabled. The gimbal camera will
adjust its pan direction according to the aircraft’s movements.
When the switch is in the middle position, the gimbal camera is in Follow Pan Controllable
Mode, the gimbal camera will adjust its pan direction according to the aircraft’s movements.
Meanwhile, the pan control is activated, use the Pan Control Knob to set the pan position of the
gimbal camera. When the switch position is down, the gimbal camera is in Global Mode. The pan
direction of the gimbal camera will be fixed regardless of the aircraft’s movements in the range of
±165°. Use the Pan Control Knob to set the pan position of the gimbal camera.
Land
Lower the landing gear using the same control
as used for retracting landing gear. Lower the
landing gear at least 12’ above the landing
area.
Slowly lower the Throttle stick below the
center position, the drone will descend slowly
and land. After lands, the motors will stop
after 2 seconds without any operation.