User's Manual

IMPORTANT NOTE: This Quick Start Guide is NOT intended to replace

the complete content included in the ST24 instruction manual. Although

the following information covers some of the basic details you need to

know we strongly recommend reading through the instruction manual

completely before charging/using the ST24.

Charging Your ST24

Use a suitable power source/supply (1.5A and 5V MAX output) and a cable with a Micro

USB connector to charge the 3.7V Li-Ion battery installed in the ST24. The time it takes to

fully charge the battery will depend on the current voltage/charge state of the battery and

the charge rate of your chosen power source/supply. For reference it will typically take

approximately 6 hours to charge a near fully discharged battery at the maximum

recommended charge rate of 1.5 amps.

1. Connect the cable with the Micro USB connector to the suitable power

source/supply

2. Connect the Micro USB connector to the corresponding port on the bottom of the

ST24

3. When the transmitter is turned on the battery icon located in the upper right-hand

corner of the screen (in select menus) will show a ‘plug’ inside while the battery is

charging

You can also remove the battery from the back of the ST24 and charge it separately using

a suitable Li-Ion battery charger and a lead with a compatible 2-pin JST connector (at a

maximum recommended charge rate of 1.5 amps).

IMPORTANT NOTE: Charging the Li-Ion battery using an incompatible charger

(such as a NiCd or NiMH battery charger), or even a compatible battery charger with

the incorrect settings, may result in damage to the battery or even fire resulting in

property damage and/or personal injury.

Using Your ST24

In the Radio Control (RC) Mode

For RC-only (non-FPV/camera-equipped) models

1. Power on the ST24 and enter RC mode

 Slide the Power Switch to the left to power on the ST24

NOTE: The switch does not extend beyond the surface of the transmitter to