User's Manual

INSTALLING THE SMART DEVICE
SD CARD INSTALLATION
POWRING ON/OFF
STEP 3: Push the flight battery into the aircraft until hearing a 'click'.
STEP 1:
Pull out the smart
phone holder from
the remote controller.
STEP 3:
Connect the smart phone
with the remote controller
through the iPhone or
Android cable.
STEP 2:
Put your smart phone
on the holder.
P
ress the power button and hold for two seconds to power on/off the remote controller and the Mantis G in
turn. When the main LED flashes blue slowly and emits a rising tone, the aircraft completes its initialization and
boots up successfully.
Power on your smart phone, scan the QR code and download the Yuneec Pilot APP on your smart phone.
09
NOTICE: Before using the Mantis G, a Micro SD card should be inserted
i
nto the camera.
NOTICE: Do not move the Micro SD card from the Mantis G when it is
shooting.
STEP 1: Slide the memory card into the card slot according to the
direction of the arrow.
STEP 2: When fully inserted, the card clicks into place. To remove the
card, place your fingernail against the edge of the memory card and
lightly press it further into the Micro SD card slot. The card springs out
far enough to be removed.
CAUTION: Keep the memory card out of the reach of children to prevent
swallowing.
WARNING: After inserting the Micro SD card in the computer, be sure to
safely eject the SD card properly so it does not corrupt the card. If you
directly pull out the Micro SD card from the computer and plug it into
the aircraft, the aircraft with this Micro SD card won’t support the digital
video downlink, and the photo taking and video recording function can
not be performed.