User Manual

connected.
-Consult the dealer or an experienced radio/TV technician for help
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
RF exposure statement
This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of 20 cm
between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Cet équipement est conforme aux limites d’exposition aux rayonnements de la IC établies pour
un environnement non contrôé. Cet équipement doit être installé et fonctionner à au moins 20
cm de distance d’un radiateur ou de votre corps.
ORIGINAL EQUIPMENT MANUFACTURER (OEM) NOTES
The OEM must certify the final end product to comply with unintentional radiators (FCC Sections
15.107 and 15.109) before declaring compliance of the final product to Part 15 of the FCC rules and
regulations. Integration into devices that are directly or indirectly connected to AC lines must add
with Class II Permissive Change.
The OEM must comply with the FCC labeling requirements. If the module’s label is not visible
when installed, then an additional permanent label must be applied on the outside of the finished
product which states: “Contains transmitter module FCC ID: 2ACS5-YUNOFDM. Additionally, the
following statement should be included on the label and in the final product’s user manual: “This
device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interferences, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.”
The module is limited to installation in mobile or fixed applications. Separate approval is required