User Manual
USER MANUAL
INTRODUCTION
The CGO SteadyGrip™ is a ground handle designed to extend the CGO-GB 3-axis
gyro stabilized camera from the sky to the ground, allowing you to capture amazing
acon shots easier than ever before. The camera pitch controller allows precise
camera angle control on the go using your mobile device as a display. The Steady-
Grip's ergonomic design is capable of holding up to a 6.4 inch mobile device.
The SteadyGrip™ paired with Yuneec’s CGO2-GB Full-HD 3-Axis Stabilized Gimbal
Camera System allows you to capture fluid footage right out the box. Please take
the me to read through this enre instrucon manual for more informaon on
safety, baery charging, camera controls and more before filming your first hit
video. Please also visit www.Yuneec.com for addional informaon including
product updates, bullens, videos and more.
CGO-2GB (available separately) is an innovave combinaon of 3-axis brushless
gimbal, camera and digital video downlink.
The Self-Stabilizing gimbal makes it possible to capture amazing photographs and
video footage for an array of uses. And the built-in digital video link delivers
streaming video to 5.8GHz WiFi compable iOS® and Android™ equipped devices
including smart-phones and tablets as well as YUNEEC Personal Ground Staons.
GENERAL SAFETY PRECAUTIONS AND WARNINGS
WARNING: Failure to use this product in the intended manner as described in
instrucon manual can result in damage to the product, property and/or cause
serious injury. This product is not a toy! If misused it can cause serious bodily harm
and damage to property.
WARNING: As the user of this product you are solely and wholly responsible for
operang it in a manner that does not endanger yourself and others or result in
damage to the product or the property of others.
Always allow CGO2-GB and SteadyGrip™ to inialize properly by seng the
SteadyGrip™ on a flat and stable surface prior to switching it on and allowing the
SteadyGrip™ and CGO2-GB to inialize properly which somemes takes about 4-8
seconds.
Always operate your SteadyGrip™ in a respecul and safe manner.
Do not aempt to operate your equipment in areas with potenal magnec and/or
radio interference including areas nearby broadcast towers, power transmission
staons, high voltage power lines, etc.
FCC INFORMATION
This device complies with part 15 of the FCC rules. Operaon is subject to the
following two condions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operaon.
CAUTION: Changes or modificaons not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This product contains a radio transmier with wireless technology which has been
tested and found to be compliant with the applicable regulaons governing a radio
transmier in the 5.8GHz frequency range.
Antenna Separaon Distance:
Maintain a separaon distance of at least 50mm (2 in) between your body (not
including your fingers, hands and wrists) and the antennas to meet the RF exposure
safety requirements determined by FCC regulaons. Holding the SteadyGrip™ by
the ergonomic handle with your arm straight out in front of you, will provide
adequate antenna separaon distance.
BATTERY WARNINGS AND USAGE GUIDELINES
WARNING: Alkaline Baeries May explode or leak, and cause burn injury if
recharged, disposed of in fire, mixed with a different baery type, inserted
backwards or disassembled. Replace all baeries at the same me. Do not carry
baeries loose in your pocket or purse. Do not remove the baery label.
WARNING: All instrucons and precauons must be read and followed exactly and
you must follow instrucons of the baery manufacturer.
WARNING: procedures, which if not properly followed, create the probability of
property damage, collateral damage and serious injury or create a high probability
of superficial injury.
Failure to exercise care while using this product and comply with the following
condions and guidance could result in product malfuncon, excessive heat, fire,
property damage, and ulmately injury.
Lithium lon baeries are not toys. For the purpose of the document Li-lon, Li-Po,
Li-Fe, NiCd or NiMH baeries will be described as "Baeries".
Handling and Storage:
● Never alter, puncture or impact Baeries or related components.
● Do not directly connect the terminals with metal objects. This will short-circuit
Baeries, resulng in heat and electrical discharge.
● Never store loose Baeries together, the Baeries' terminals may contact one
another causing a short circuit.
● Never expose Baeries to extreme temperatures or direct sunlight.
● Always disconnect Baeries when not in use.
Before the First Charge:
● Ensure baeries are not damaged, as this may cause a short circuit of fire.
Charging
● Always refer to your charger's manual to ensure safe operaon.
● Always charge Baeries in an open area away from flammable materials, liquids
and surfaces.
● Never charge Baeries that are hot to the touch (above 120°F)
If at any me Baeries become damaged, hot, or begin to balloon or swell,
disconnue charging (or discharging) immediately. Quickly and safely disconnect
the charger. Then place the Baeries and/or charger in a safe, open area away from
flammable materials in an approved Li-Po bag to observe. Aer one hour, remove
the Baeries from service. DO NOT connue to handle, aempt to use, or ship the
Baeries. Failure to follow these procedures can cause damage to Baeries,
personal property or cause serious injury.
Damaged or swollen Baeries can be unstable and very hot. DO NOT touch
baeries unl they have cooled. Dispose of baeries in the manner required by
your city, county, state or country. Contact the appropriate Yuneec Product
Support Office to speak to a service technician for more informaon.
In the event of fire, a Class D, dry chemical fire exnguisher must be used then
baeries must be placed inside of an approved Li-Po bag.
Addional Guidelines and Warnings:
● In the event of a crash, always quickly and safely disconnect and remove Baeries
from the model. Then follow the previously listed safety procedures.
● If the internal contents of Baeries come into contact with your skin, wash the
affected area(s) with soap and water immediately. If it comes into contact with your
eye(s), flush them with generous amounts of water for 15 minutes and seek
immediately medical aenon.
INSTALLING THE AA BATTERIES
WARNING: Alkaline Baeries May explode or leak, and cause burn injury if
recharged, disposed of in fire, mixed with a different baery type, inserted
backwards or disassembled. Replace all baeries at the same me. Do not carry
baeries loose in your pocket or purse. Do not remove the baery label.
ATTACHING THE CGO2-GB TO THE STEADYGRIP™
WARNING: Before switching on the SteadyGrip™ it is highly recommended to first
securely aach the CGO2-GB to your SteadyGrip™.
QUICK TIP: It’s a good idea to ensure you have your microSD card with lots of
space for photos and videos handy.
STEP 1) Carefully slide the top part of the CGO2-GB (that also aaches below the
nose of the Q500 Typhoon) onto the mount below the front part of the SteadyGrip™.
A corresponding ‘click’ will be noced once the CGO2-GB has securely been
installed into the slide-in mount on the SteadyGrip™.
SPECIFICATIONS
CGO STEADYGRIP™
Height: 223mm (8.78 in)
Depth (front to back): 182mm (7.17 in)
Width: 70mm (2.76 in)
Weight (without gimbal/baeries): 200g (7.05 oz)
Required Baeries: 2850mAh Energizer® 6x 1.5V AA Baeries
(Sold Separately)
Runme: 48-64 minutes (depending on usage)
CGO2-GB
Height: 115mm (4.5 in)
Width: 74mm (2.9 in)
Depth: 135mm (1.4 in)
Weight: 185g (6.5 oz)
Video Resoluon: Full-HD 1080p 60, 50 or 48 fps(
Photo Resoluon: 12 Megapixels
Transmission Distance/Range: Up to 600m (1970 ) depending on receiving device
and environment
Transmission Band: 5.8GHz
Storage (memory): microSD Class 10 up to 128GB
CGO2 APP COMPATIBLE DEVICES
Android:
Mobile Devices with 5.8GHz Support
WINDOWS SYSTEM
REQUIREMENTS
Windows XP (Service Pack 2 or later)
or Vista
3.2GHz Penum 4 or faster
Minimum 4GB of system RAM
MAC SYSTEM
REQUIREMENTS
Mac OS® X 10.4.11 or later
2.0GHz Intel Core Duo or faster
Minimum 4GB of system RAM
NOTICES AND WARNINGS
IMPORTANT NOTE: All safety precauons and warnings, instrucons, warranes
and other collateral informaon is subject to change at the sole discreon of
Yuneec. For the most up-to-date informaon please visit the corresponding
product page at www.Yuneec.com or contact the nearest Yuneec office or
authorized distributor.
The following special language terms are used throughout the product literature to
indicate various levels of potenal harm when operang this product:
NOTICE: Procedures, which if not properly followed, create a possibility of property
damage and/or lile to no possibility of injury.
CAUTION: Procedures, which if not properly followed, create the probability of
property damage and/or a possibility of serious injury.
WARNING: Procedures, which if not properly followed, create the probability of
property damage, collateral damage and/or serious injury or create a high probability
of superficial injury.
WARNING: Read the ENTIRE instrucon manual to become familiar with the
features of the product before operang. Failure to operate the product correctly
can result in damage to the product, property and/or cause serious injury.
WARNING: This is a sophiscated consumer product. It must be operated with
cauon and common sense, and requires some basic mechanical ability. Failure to
operate this product in a safe and responsible manner could result in damage to the
product, property and/or cause serious injury. This product is not intended for use
by children without direct adult supervision. Do not use with incompable
components or alter this product in any way outside of the instrucons provided by
Yuneec. The instrucon manual contain instrucons for safety, operaon and
maintenance. It is essenal to read and follow all the instrucons and warnings
prior to assembly, setup and/or use in order to operate the product correctly and
avoid damage or serious injury.
AGE RECOMMENDATION: NOT FOR CHILDREN UNDER 14 YEARS. THIS IS NOT
A TOY.
Apple iOS:
phone4s
iphone 5,5c/5s,6,6+
ipad mini / mini+ /3/4.
OVERVIEW
CGO SteadyGrip™ Acon Ground
Handle for CGO™ Series Camera
1. CGO2-GB
2. Main Status LED
3. Pitch Control Roller Wheel
4. Rubberized Ergonomic Grip
5. On/Off Switch
6 . 6AA Baery Compartment
1
2
3
4
5
6
STEP 1) Remove the Baery Cover / Door
from the boom of the SteadyGrip™
Hold the boom of the SteadyGrip™ toward
yourself with the front part facing
downward. Slide the baery cover / door
upward with slight force and inspect the AA
baery compartment.
STEP 2) Install 6x AA Baeries
For long life and extended run me, we
recommend Energizer® 1.5V AA Baeries
which are known to have 2,850mAh of
stored energy. The SteadyGrip™ will run for approximately 48-64 minutes depending
on the gravity of usage.
STEP 3) Re-installing the Baery Cover / Door on the boom of the SteadyGrip™
Once you’ve installed 6 fresh AA baeries, Hold the boom of the SteadyGrip™
toward yourself with the front part facing downward. Slide the baery cover / door
downward with slight force and ensure you hear and feel a noceable ‘click’
indicang the baery cover / door has been closed securely.