BATTERY WARNINGS AND USAGE GUIDELINES WARNING: Lithium Polymer (LiPo) batteries are significantly more volatile than alkaline, NiCd or NiMH batteries. All instructions and warnings must be followed exactly to prevent property damage and/or serious injury as the mishandling of LiPo batteries can result in fire. By handling, charging or using the included LiPo battery you assume all risks associated with LiPo batteries.
CHARGING THE BATTERIES WARNING: Lithium Ion (LiIon) and Lithium Polymer (LiPo) batteries are significantly more volatile than alkaline, NiCd or NiMH batteries. All instructions and warnings must be followed exactly to prevent property damage and/or serious injury as the mishandling of LiIon/LiPo batteries can result in fire. By handling, charging or using the included LiIon/LiPo batteries you assume all risks associated with them.
ST10+ DISPLAY The ST10+ is equipped with a touchscreen display that allows for changing various settings and viewing real-time telemetry data and streaming video during flight. 1 2 3 4 5 6 7 8 19 9 18 10 17 11 16 12 15 14 13 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 Model Name Frames Per Second for Video Recording Button Status Information Direction to Home Point Clock/Current Time GPS Status and Number of Satellites for ST10+ 5.
TAKING PHOTOS AND RECORDING VIDEO The slider located on the left side of the ST10+ allows you to set the pitch/tilt position of the CGO2+ from approximately straight ahead (when the slider is in the uppermost position) to approximately straight down (when the slider is in the lowermost position). And you can easily set a position in between by adjusting the slider accordingly.
ST10+ AND RECEIVER BINDING Step 1) Turn on TYPHOON, and after the Main LED Status Indicator begins to flash blue rapidly, lift the back end upward approximately 45° then back down to ‘level’ two (2) times to put the aircraft/receiver into bind mode. The Main LED Status Indicator will begin to the flash orange very rapidly when the aircraft/receiver are in bind mode. Step 5) Tap the ‘Flight Settings’ button, and if required press ‘OK’ to bypass any pop up warnings/alerts.
ST10+ AND CGO2+ BINDING Step 5) if required tap the screen (outside of the pop up status window) to bypass the RC and WiFi connection process, then tap the ‘Flight Settings’ button and press ‘OK’ to bypass any pop up warnings/alerts. Step 1) Turn on the ST10+, and if required tap the screen (outside of the pop up status window) to bypass the RC and WiFi connection process. Step 2) Tap the ‘Model Select’ button, and if required press ‘OK’ to bypass any pop up warnings/alerts.
CERTIFICATION INFORMATION FCC STATEMENT: This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.