Quick Start Guide
ST10+ AND RECEIVER BINDING
Step 1) Turn on TYPHOON, and
aer the Main LED Status Indicator
begins to flash blue rapidly, li the
back end upward approximately 45°
then back down to ‘level’ two (2)
mes to put the aircra/receiver into
bind mode. The Main LED Status
Indicator will begin to the flash
orange very rapidly when the
aircra/receiver are in bind mode.
2 x 45+°
Step 2) Turn on the ST10+,
and if required tap the
screen (outside of the pop
up status window) to
bypass the RC and WiFi
connecon process.
Step 3) Tap the ‘Model
Select’ buon, and if
required press ‘OK’ to
bypass any pop up
warnings/alerts.
Step 4) Select the exisng
model (for example:
‘TYPHOON’) you would
like to bind to (or create a
‘New Model’), and if
required press ‘OK’ to
bypass any pop up
warnings/alerts.
Step 5) Tap the ‘Flight
Sengs’ buon, and if
required press ‘OK’ to
bypass any pop up
warnings/alerts.
Step 6) Tap the ‘Bind’
buon and select the
‘SR24_XXXXX’ receiver
listed in the column under
‘Model’, then tap ‘OK’ aer
the connecon has been
established.
Step 7) Tap the ‘Back’
buon two (2) mes to
return to the main screen
and the model/receiver
should automacally
connect to the ST10+.
5
SR24_16042