Operation Manual
CHARGING THE BATTERIES
WARNING: Lithium Ion (LiIon) and Lithium Polymer (LiPo) baeries are
significantly more volale than alkaline, NiCd or NiMH baeries. All
instrucons and warnings must be followed exactly to prevent property
damage and/or serious injury as the mishandling of LiIon/LiPo baeries
can result in fire. By handling, charging or using the included LiIon/LiPo
baeries you assume all risks associated with them. If you do not agree
with these condions please return the complete product in new, unused
condion to the place of purchase immediately.
CHARGING THE LIPO FLIGHT BATTERY
You can power the SC3500-3 charger from a 100-240V AC outlet using the
AC adapter/power supply, or from a 12V DC accessory socket/cigaree
lighter receptacle in a vehicle using the corresponding adapter. Once
you’ve verified the charger is powered on and ready to charge (green
blinking LED), plug the balance connector charge lead into the charger, then
connect the LiPo flight baery to the charge lead. The baery will begin
charging (red blinking LED) and it will take approximately 2 hours to charge
a fully discharged (not over-discharged) baery.
CHARGING THE LI-ION ST10 BATTERY
You can charge the LiIon baery installed in the ST10 from a 100-240V AC
outlet using the USB adapter/charger, or from a suitable USB power source
(2.0 amps max), with the USB to micro USB cable. While the ST10 is
powered off connect the cable to the USB adapter/charger, then plug it
into the USB connector/charging port on the right side. Aer approximate-
ly 30-45 seconds the LED indicator for the baery will blink blue while the
baery is charging, and will glow solid blue when the baery is fully
charged. It will take approximately 5.5 hours to charge a fully discharged
(not over-discharged ) baery.
NOTE: The AC plug type will vary depending on the region in which the
product was imported/purchased (AU = Australian; EU = European; UK =
United Kingdom; US = United States).
8