Operation Manual

ST10 ACCESSORIES

You can install the included and oponal-use Neck Strap to help hold and

support the ST10. You can also install the included and oponal-use LCD

Screen Sun Shade/Shield to help improve viewing in sun light.

QUICK TIP: It may be helpful to apply suitable an-glare screen protector

material over the LCD screen to further improve viewing in sun light.

Moving the le-hand sck to the le will turn (yaw) the nose of the Q500

to the le about the vercal axis. And moving the sck to the right will turn

(yaw) the nose of the Q500 to the right.

FLIGHT CONTROLS

NOTE: The informaon in this and the following secons refers to the

default ‘Mode 2’ control conﬁguraon of the ST10. The le-hand sck on

the ST10 controls the throle (climb/descend) and rudder (yaw le/right)

channels.. When the le-hand sck (also known as the throle sck) is in

the middle posion during ﬂight the Q500 will maintain the current

altude. As you move the sck upward the Q500 will climb, and as you

move the sck downward the Q500 will descend. The farther away from

the middle posion you move the sck the faster the Q500 will climb or

descend.

IMPORTANT NOTE: The maximum altude is limited to 400 feet (122

meters) AGL (Above Ground Level) in both Smart and Angle (Pilot) Mode.

And although this limit can be adjusted using the USB interface/program-

mer and soware we strongly recommend using the default limit at all

mes.