Operation Manual
ST10 AND RECEIVER BINDING
Step 1) Turn on the Q500, and aer
the Main LED Status Indicator begins
to flash blue rapidly, li the back end
upward approximately 45° then back
down to ‘level’ two (2) mes to put
the aircra/receiver into bind mode.
The Main LED Status Indicator will
begin to the flash orange very rapidly
when the aircra/receiver are in bind
mode.
2 x 45+°
Step 2) Turn on the ST10,
and if required tap the
screen (outside of the pop
up status window) to
bypass the RC and WiFi
connecon process.
Step 3) Tap the ‘Model
Select’ buon, and if
required press ‘OK’ to
bypass any pop up
warnings/alerts.
Step 4) Select the exisng
model (for example:
‘Q500’) you would like to
bind to (or create a ‘New
Model’), and if required
press ‘OK’ to bypass any
pop up warnings/alerts.
Step 5) Tap the ‘Flight
Sengs’ buon, and if
required press ‘OK’ to
bypass any pop up
warnings/alerts.
Step 6) Tap the ‘Bind’
buon and select the
‘SR12S_XXXXX’ receiver
listed in the column under
‘Model’, then tap ‘OK’ aer
the connecon has been
established.
Step 7) Tap the ‘Back’
buon two (2) mes to
return to the main screen
and the model/receiver
should automacally
connect to the ST10.
26