User manual

ST10+ Accessories

You can install the included and oponal-use Neck Strap to help hold and

support the ST10+. You can also install the included and oponal-use LCD

Screen Sun Shade/Shield to help improve viewing in sun light.

QUICK TIP: It may be helpful to apply suitable an-glare screen protector

material over the LCD screen to further improve viewing in sun light.

CAUTION: Do not bend, or move around in excess as the strap can come

unhooked from the ST10+ and potenally fall and damage the sensive

electronic components.

Moving the le-hand sck to the le will turn (yaw) the nose of the

TYPHOON to the le about the vercal axis. And moving the sck to the

right will turn (yaw) the nose of the TYPHOON to the right.

Flight Controls

NOTE: The informaon in this and the following secons refers to the

default ‘Mode 2’ control conﬁguraon of the ST10+. The le-hand sck on

the ST10+ controls the throle (climb/descend) and rudder (yaw le/right)

channels.. When the le-hand sck (also known as the throle sck) is in

the middle posion during ﬂight the TYPHOON will maintain the current

altude. As you move the sck upward the TYPHOON will climb, and as

you move the sck downward the TYPHOON will descend. The farther

away from the middle posion you move the sck the faster the TYPHOON

will climb or descend.

IMPORTANT NOTE: The maximum altude is limited to 400 feet (122

meters) AGL (Above Ground Level) in both Smart and Angle (Pilot) Mode.

And although this limit can be adjusted using the USB interface/program-

mer and soware we strongly recommend using the default limit at all

mes.

Maximum Climb Rate:

2m/s (6.6f/s)