User manual

ST10+ and Receiver Binding
Step 1) Turn on the TYPHOON, and
aer the Main LED Status Indicator
begins to flash blue rapidly, li the
back end upward approximately 45°
then back down to ‘level’ two (2)
mes to put the aircra/receiver into
bind mode. The Main LED Status
Indicator will begin to the flash
orange very rapidly when the
aircra/receiver are in bind mode.
2 x 45+°
Step 2) Turn on the ST10+,
and if required tap the
screen (outside of the pop
up status window) to
bypass the RC and WiFi
connecon process.
Step 3) Tap the ‘Model
Select’ buon, and if
required press ‘OK’ to
bypass any pop up
warnings/alerts.
Step 4) Select the exisng
model (for example: ‘the
TYPHOON’) you would like
to bind to (or create a ‘New
Model’), and if required
press ‘OK’ to bypass any
pop up warnings/alerts.
Model: 4K Welcome,Pilot 10:48:28 pm
10
GPS
Ready
SAT
13
POS
00.0000E
00.0000N
MODE
Angle
ALT
21.4 
VOLTS
12.3 V
G-SPD
0.0 mph
DIS
22.5 
System Sengs Flight Sengs Model Select
HOME
27
Step 5) Tap the ‘Flight
Sengs’ buon, and if
required press ‘OK’ to
bypass any pop up
warnings/alerts.
Step 6) Tap the ‘Bind’
buon and select the
‘SR24_XXXXX’ receiver
listed in the column under
‘Model’, then tap ‘OK’ aer
the connecon has been
established.
Step 7) Tap the ‘Back’
buon two (2) mes to
return to the main screen
and the model/receiver
should automacally
connect to the ST10+.
Model: 4K Welcome,Pilot 10:48:28 pm
10
GPS
Ready
SAT
13
POS
00.0000E
00.0000N
MODE
Angle
ALT
21.4 
VOLTS
12.3 V
G-SPD
0.0 mph
DIS
22.5 
System Sengs Flight Sengs Model Select
HOME
Model: 4K Welcome,Pilot 10:48:28 pm
10
SR24_16042
SR24_16042
Not connected
Model Camera
Model: 4K Welcome,Pilot 10:48:28 pm
10
Model Select
New Model gh