User manual

30
WARNING: Alkaline Baeries May explode or leak, and cause burn injury if
recharged, disposed of in fire, mixed with a different baery type, inserted
backwards or disassembled. Replace all baeries at the same me. Do not
carry baeries loose in your pocket or purse. Do not remove the baery
label.
STEP 1) Remove the
Baery Cover / Door from
the boom of the Steady-
Grip™
Hold the boom of the
SteadyGrip™ toward
yourself with the front
part facing downward.
Installing The Steadygrip™ Baeries
WARNING: Before switching on the SteadyGrip™ it is highly recommended
to first securely aach the CGO3 to your SteadyGrip™.
QUICK TIP: It’s a good idea to ensure you have your microSD card with lots
of space for photos and videos handy.
STEP 1) Carefully slide the top part of the CGO3 (that also aaches below the nose of
the Q500 the TYPHOON) onto the mount below the front part of the SteadyGrip™. A
corresponding ‘click’ will be noced once the CGO3 has securely been installed into
the slide-in mount on the SteadyGrip™.
Aaching The CGO3 to The Steadygrip™
Slide the baery cover / door upward with slight force and inspect the AA
baery compartment.
STEP 2) Install 8x AA Baeries
The use of rechargeable baeries is strongly recommended. Alkaline
baeries only support the device to work 15 minutes.
STEP 3) Re-installing the Baery Cover / Door on the boom of the
SteadyGrip™
Once you’ve installed 8 fresh AA baeries, Hold the boom of the Steady-
Grip™ toward yourself with the front part facing downward. Slide the
baery cover / door downward with slight force and ensure you hear and
feel a noceable ‘click’ indicang the baery cover / door has been closed
securely.
STEP 2) Carefully connect the CGO3’s power/control connector to the power/control
port of the CGO SteadyGrip™ and then insert a microSD card into the corresponding slot
on the boom of the CGO3. You can use the included 16GB card (from your RTF
package) or any Class 10 microSD card up to 128GB.
STEP 3) Powering on and inializaon. Place your CGO SteadyGrip™ on a flat and stable
surface, then switch on the Steady-
Grip™ and it will inialize aer 4-8
seconds of no movement or
vibraon.
SteadyGrip™ Main LED Status:
Upon Powering on: Green LED blinking for twice and then solid GREEN for READY TO USE!
Pitch Follow Funcon: GREEN LED blinking
Low Voltage Warning: RED LED blinking slowly
Power Cut-off: RED LED blinking quickly