Instructions

ManualsBrandsYuneec ManualsCarsTyphoon H3 Industrial drone RtF Camera drone

Takeoff

Option 1

Press and hold the START/STOP button until the aircraft boot up.

Step back approximately 26 feet (8 meters) behind TYPHOON H3.

When there is suitable GPS signal for both the ST16S Ground Sta-

tion and TYPHOON H3, slowly raise the left-hand stick to slightly

above the center position. The aircraft will take off and climb slowly

(or raise the stick further until it does). Allow the stick to return to the

center position when the aircraft reaches the desired altitude.

Binding

Binding the aircraft and ST16S

NOTICE: The aircraft and ST16S Ground Station are already bound out of factory. There is no need to

bind them. Pilot can follow the steps below if binding is needed.

STEP 1: Power on the TYPHOON H3. After initialization completes, the two LEDs on rear arms will blink

blue.

STEP 2: Lift the aircraft upside down until all LEDs blink yellow quickly, and then turn the aircraft back

on straight and level ground.

STEP 3: Switch on the ST16S Ground Station. Wait a few seconds for all systems to be boot up.

STEP 4: Tap the settings icon [ ] on the right top corner of the ST16S. Select the icon [ ] and

slid to the "Drone" selection.

STEP 5: Tap the refresh icon [ ]，and then tap OK to unbind RC link. Select the corresponding

receiver listed in the column. Wait until a tip pops up to indicate the binding is completed.

Binding the aircraft and ION L1 PRO

Step 1.

Switch on the ST16S followed by the TYPHOON H3 aircraft.

Step 2.

Tap the[ ]on the top right corner on the main interface of

ST16S, then tap the[ ]on the switching interface.

Step 3.

Tap the serial number of the ION L1 PRO when the following

window pops up. (If multiple Yuneec UAS are used,check the ID

number on the side of each camera to assure correct camera se-

lection/binding).

Step 4.

Using the password “1234567890”, authorize the camera and tap

"OK" to conrm.

NOTICE:

If the connection process is delayed, close the pop up

window and then repeat the above steps.

00 : 35 : 25

System Setting

12.6V

FSK

WIFI

Roll 120˚

GPS

VOL

FSK

WiFi

CHA

POS

CHA

POS

IONL1P