Instructions
II. Safety Setting
The maximum relative ight height of the aircraft can
be set in the safety settings. Before unlocking, the
height setting range is 20-120m; after unlocking, the
height setting range is 20-500m.
1.Setup method
Directly slide the maximum relative ight height set-
ting slider to set the maximum relative ight height.
Once the hand leaves the screen, the setting is com-
pleted. After the setting, the remote control screen
will pop up a green √, indicating the setting is suc-
cessful.
2.Unlocking method
Click the lock icon on the right, and then click the
Agree button in the pop-up box to unlock. If you do
not agree with the exemption prompt in the pop-up
box, please click the disagree button, and the height
limit of the aircraft will not be unlocked. After unlock-
ing, the lock icon turns to red open, indicating that
the height limit unlocking is successful, and the
height limit range is expanded to 20-500m.
NOTICE:
if you need to lock again, click the red unlock
icon to adjust the maximum height to 120m
III. Advanced settings
LED lamp
Through the setting of LED light, the user can turn on the LED light on the aircraft arm, especially in
the use scene of night shooting, which can effectively avoid the inuence of the LED light on the aerial
photography effect
The user can set the on / off of the aircraft arm light by clicking the circle in front of the disable front
light, disable all lights and enable all lights.
IV. Other settings
1. Aircraft GPS
After sliding, the GPS switch can be turned off. The aircraft GPS will not intervene in the aircraft ight.
The aircraft control mode is the same as that in angle mode. You need to see the nose direction to op-
erate correctly. Otherwise, there will be the risk of wrong rudder, ying loss and collision with foreign
matters. After turning off the GPS switch, any functions and modes that need to use GPS will not oper-
ate. Please be careful to y, usually only in GPS module Or when the geomagnetic module is strongly
interfered and the aircraft is out of control, it will be considered to turn off the GPS and drive the UAV
manually. Generally, do not turn off the GPS switch.
2. Aircraft realsense settings
Click the circle in front of the option to select whether the realsense module is installed. By default, the
realsense module is not installed in the factory of the thypoon H3 aircraft. Please keep the option to
Realsense Disable in the setting menu.
19