Instructions

V. If it's the rst time you bind the slave remote to

the mast remote , please tap the Accept button on

the mast remote screen.

VII. Operation Method

1. Master remote can only control the drone , can't

control the gimbal and camera.

2. Tap the gimbal operation method select button ,

you can select the gimbal operation mode

2.1Same with the single remote mode

2.2 Joystick control mode, drone pitch joystick

controls the gimbal tilt; drone roll joystick controls

gimbal pan direction.

VI. Bind nished

Master remote Slave remote

NOTICE:

Tap Stop Team Mode Button you can exit team mode ,no matter on the Master remote or

the Slave remote

Landing

There are three ways to land the aircraft:

1. Position the TYPHOON H3 above the area where you would like to land. Lower down the retract-

able landing gear, and then slowly lower the left-hand stick to below the center position. TYPHOON

H3 will descend slowly and land.

2. Activate Home Mode and TYPHOON H3 will automatically y itself back to the home point and

land.

3. Press the icon ( ), then slide the sliding block, and the aircraft will land automatically.

WARNING: Always land as soon as possible after the rst low level voltage battery warning, or land

immediately after the second level low voltage battery warning by the Motor LED Status Indicators

ashing rapidly.