Instructions

Camera Control

Gimbal Camera Tilt Control

There is a gimbal tilt mode switch on ST16S labeled “S1.” When the switch is in up/middle position,

the ION L1 PRO (or other gimbal system) gimbal camera is in Angle Mode. Use the slider (C) on the

under-left side of the ST16S to set the tilt position of the gimbal camera. When the S1 is in the bottom

position, the gimbal camera is in Velocity Mode. When the slider (C) is in the middle position, it

means the velocity rate is 0 for the ION L1 PRO, disabling tilt. When the slider (C) is above the middle

position, the ION L1 PRO will enable upward tilt/angle. When the slider (C) is below the middle posi-

tion, the ION L1 PRO will enable downward tilt. The distance between the slider (C) and the middle

position determines the tilt speed, the further distance, the faster the tilt speed.

CAUTION:

Video recording must be stopped to take still photos. It will take approximately 1-2 sec-

onds to capture a still photo and before another image may be taken.

CAUTION:

Always stop recording video before powering down TYPHOON H3 to avoid loss of video

data.

NOTICE:

Only when in Velocity mode may the gimbal camera be tilted upwards 30°maximum.

Gimbal Camera Pan Control

The gimbal pan mode switch on ST16S (S2) enables the Follow Mode. When the switch position is

UP, the gimbal camera is in Follow Mode. The pan control of the gimbal camera is disabled when the

switch position is UP. The gimbal camera will adjust its pan direction per the

aircraft’s

movements.

When the switch is in the middle position, the gimbal camera is in Follow Pan Controllable Mode, the

gimbal camera will adjust its pan direction per the

aircraft’s

movements. Use the Pan Control Knob to

set the pan position of the gimbal camera. When the switch position is down, the gimbal camera is in

Global Mode. The pan direction of the gimbal camera will be xed regardless of the

aircraft’s

move-

ments. Use the Pan Control Knob to set the pan position of the gimbal camera.

Gimbal Control Setting

1. Open the remote control and wait for the remote control to start

2. Click the settings button

3. Turn on the remote control setting switch to enter the remote control setting page

A B

Button A = Taking pictures

Button B = Start/Stop Recording videos