Instruction Manual

Wireless camera x 1
7" wireless monitor x 1
Mount Bracket x 1
Monitor sunshade x 1
Antenna x 2
Screw Kit for Camera Installation x 1
Camera Power Cable x 1
Package contents
Before drilling, please check that no cable or wiring is on the other side of the wall.
Please clamp all wires securely to reduce the possibility of them being damaged while
vehicle is in use.
Keep all cables away from hot or moving parts and electrical noisy components.
We recommend doing a benchmark test before installation to insure that all components
are working properly.
Step 1: Choose the monitor and camera locations.
Step 2: Install all cabels in vehicle, when necessary a 0.8 (20mm) hole should be drilled
for passing camera cable through vehicles walls. Install split grommets where
applicable.
Step 3: Once all cables and wiring have been properly routed, perform a system function
test by temporarily connecting the system. If the system seems to not be operating
properly see troubleshooting.
Camera Installation
1. Attach camera bracket close to rear marker lights, centered on vehicle.
2. Camera: drill a 20mm (0.8in) diameter hole into vehicle body near the camera and bracket.
Insert camera cable into vehicle not to kink cable) and fit grommet into hole. Apply sealant
around grommet to increase resistance to water penetration. connect camera to the
camera extension cable which runs inside the vehicle.
Before Beginning Installation
Installation Guide
Troubleshooting
Monitor Displays Blue Screen & Displays No Signal
Do a hard reset, unplug all cables and power cables and leave them out
for 2 minuteS and then re-connect them.
Check to ensure that the connection to the camera is tight.
Monitor Will Not Power-Up ( no backlight no power button )
Check fuse
Check 12v+ to monitor
No Image On Screen
Verify camera is connected with antenna
Verify camera is connected to cable
1 10