Instruction Manual

3. Feed as much cable as possible into vehicle with clamp securely. This reduces the
possibility of cable being hooked or snagged. The aviation camera cable uses aircraft
grade connectors which means the camera cable can be exposed to all weather
conditions.
4. Attach camera to bracket using screws and adjust the angle.
5. Wiring camera
connect the POWER (red) to 12V and the GROUND (black).
1. To attach the pedestal mount to the dashboard or to the headliner use self-tapping
screws and/or the adhesive pad.
2. Attach monitor to mount, and adjust mounting angle to allow optimum driver viewing
comfort.
Infrared technology built into camera IRs are activated automatically according to the
lighting conditions.
Grid lines function can be turned on/off by manually from menu.
(Note: if connecting power directly to battery, the camera is always ON and therefore
can drain battery. Therefore it is recommended to connect power to an ignition
switchedaccessory power source.)
Monitor
Installation Guide
Install the monitor
Antenna Mounting Position
Adjustment Wheel
Thumb Screw
SD Card slot
Remove the screw and detach the cover of
SD card slot. Then insert the SD card and
attach its cover by tightening the screw.
Cameras
Pairing
Record
Playback
View mode
Setting
Press " Menu" button
Press " +" or "-" scroll to “ PLAYBACK"
Press "OK"
Press " +" or "-" scroll to the footage you want to playback
Press " OK", playback starts
Press " Menu" button
Press " +" or "-" scroll to “ View mode"
Choose desired view mode when you have two or more cameras installed, Press "OK"
If you hope to see each camera in loop viewing automatically, choose
and " SCAN" appears on the screen in this mode
How to playback the recordings saved
How to choose display view mode
9
Cam eras
Pai ring
Rec ord
Pla yback
Vie w mode
Set ting