Specifications

YG-1540001/2 HARDWARE SPECIFICATION

TNS21252 Rev1.0

■ Supports Legal Regulation

This product complies with the regulations of the Radio Law of the United States and Canada

(FCC, IC) and is certified.

Model Name：YG-1540001 Model Name：YG-1540002

FCC ID:WSLYG1540001 FCC ID:WSLYG1540002

IC：8213A-YG1540001 IC：8213A-YG1540002

・This device complies with Part 15 of the FCC Rules

and RSS-Gen of IC Rules.

Operation is subject to the following two conditions：

(1) This device may not cause harmful interference, and

(2) This device must accept any interference, including interference that may cause

undesired operation.

L'exploitation est soumise aux deux conditions suivantes：

(1) Cet appareil ne doit pas causer d'interférences nuisibles, et

(2) Cet appareil doit accepter toute interférence, y compris les interférences pouvant

provoquer un fonctionnement indésirable.

・CAN ICES-3 (A)/NMB-3(A)

FCC CAUTION：

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE：

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in

a commercial environment. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

RF exposure compliance

1) To comply with FCC/IC RF exposure compliance requirements, a separation distance of at

least 20 cm must be maintained between the antenna of this device and all persons.

2) This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

Conformité à l'exposition aux RF

1) Pour se conformer aux exigences de conformité d'exposition RF FCC/IC, une distance de

séparation d'au moins 20 cm doit être maintenue entre l'antenne de cet appareil et toutes

les personnes.

2) Cet émetteur ne doit pas être co-localisé ou fonctionner en conjonction avec une autre

antenne ou émetteur.