User's Manual

Nov/5th/2002
7
manage network management and monitor of network devices and their functions. If
SNMP is enabled, devices can use SNMP tool to manage and monitor the Wireless
LAN Smart Access Point from remote control.
 DHCP Client
Assign an IP address to the Wireless station. You may either set the wireless station to
obtain an IP address from DHCP server, or to be assigned with a fixed IP address. If
DHCP is enabled, the IP Address field displays the IP Address that is dynamically
assigned to the AP by the network DHCP server and the IP Mask field displays the IP
Mask utilized by the network DHCP server. The default setting is: Disable
 Assigning the IP Address
Assign an IP address to your Access Point if you wish to configure the Wireless
Access Point via the Web Management. Consult your network administrator to obtain
an available IP address (the default IP address is 192.168.1.1). For further setup
please refer to the following section.
 Assigning the subnetmask
Assign a subnet mask to your Access Point if you wish to configure the Wireless
Access Point via the Web Management. Consult your network administrator to obtain
an available subnet mask. For further setup please refer to the following section.
 Assigning the default gateway
Assign an default gateway to your Access Point if you wish to configure the Wireless
Access Point via the Web Management. Consult your network administrator to obtain
an available default gateway.
After setting the parameters, click the APPLY button to make the changes take effect. To
return the previous page, click the CANCEL button.
 Default
You may click on Default button to enable you to restore the Wireless LAN Smart Access
Point’s default setting.