User's Manual

16
Step 8-3) PPPoE Settings: Select PPPoE Settings if your ISP requires the
PPPoE protocol to establish an Internet connection. You will
have to enter the following information:
Parameter Description
User name Enter the user name of your ISP account.
Password Enter the password of your ISP account.
Retype password Enter the password of your ISP account again to
re-confirm.
Connection Type Select ONE.
Always Connect - The VPN Gateway will always
connect with your ISP. If this is the case, the Idle
Time function is unavailable.
Trigger on Demand – Once the VPN Gateway
detects any packets want to get to Internet, the
VPN Gateway will connect with your ISP
automatically.
Manual – You can manually disconnect/connect
with your ISP for the WAN port (Cable/xDSL). If
this is the case, you have to go to the DEVICE
STATUS page and click Connect button to
establish the connection or click Disconnect
button to disconnect the connection.
Dynamic/Fixed: Select ONE.
Dynamic - If your ISP will automatically assign
you an IP address
Fixed - If your ISP has given you a fixed IP
address already, then enter that IP address in the
IP assigned by your ISP box. Also enter the
subnet mask (provided by ISP) in the IP Netmask
box
Note: Once you have filled in the above information, click “Next” to proceed
to the next step. Proceed to step 9 (Step D) ISP Additional Settings of this
manual