User's Manual

53
Parameter Description
Protocols Select the Transport protocol type (TCP or UDP)
for the Destination Port Range (below) that will
be filtered
IP Address Range Enter the LAN IP address range that you wish to
apply this filter rule to. These are the LAN users’
IP addresses that you wish to apply this filter rule
to. If you only want to specify one IP address for
this filter rule then enter the same IP address in
both the From and the To box.
Note: You need to give your LAN PC clients a
fixed/static IP address for the filter rule to work
properly.
Destination Port Range Enter the Internet application/service (port
number range) for the above IP address range
that you wish to apply this filter rule to. If you only
want to specify one service port then input the
same service port in both the boxes.
Add a Filter Entry setting
Click the Add button to add the configuration into
the LAN Side Filter Table.
Delete a Filter Entry setting
Check the LAN Side Filter Table’s Del box and
click the DEL button to delete a configuration.