User's Manual

http://

WAN IP Address

Port No

Parameter Description

SYSTEM ADMIN You will have to enable the Allow remote user to

configure the device to use the remote web-

based configuration function. Once you have

enabled this function, type the device’s WAN IP

address and the HTTP port No

(e.g. http://202.19.100.1:1023) into the browser

of the specified remote administrator.

If the HTTP port number, is NOT the default

PORT No. 80, then the LAN administrator

must

also enter the new port number, specified in

HTTP port No, in order to access the device’s

web-based configuration, e.g. Device LAN IP

address with HTTP port no 1023

(http://192.168.2.1:1023)

Allow remote user to ping the device: If you

enable this function – the device will respond to

any pings it gets from the Internet. If you disable

this function, the device will not respond to any

ping requests.

SYSTEM LOG The System Log function allows the administrator

to assign an IP address to a server on which a

log server is running. When a particular event

occurs, the router will send a notification to the

log server. The log server can then present the

log to the administrator. [Free log server can be

downloaded from Internet, such as Kiwis SysLog

Daemon]