User's Manual

Follow these steps while using Access Control:

1. In this Wireless Access Point’s left page, choose the Access Control option from the

Wireless Setup.

2. If you want to enable Access Control feature, click the check box next to “Turn Access

Control on”.

3. Select the desired Access Control Database: Local MAC Address Database and RADIUS

MAC Address Database.

Local MAC Address Database: The Access Point will use the local MAC address table

for Access Control.

RADIUS MAC Address Database: The Access Point will use the MAC address table

located on the external Radius server on the network for Access Control.

4. Then, either select form the list of available wireless stations that your Access Point has

found or enter the MAC address for each client. After enter the MAC Address, click

“Add” button in the MAC Address field to be managed.

5. Click “Delete” button if you wish to remove the MAC address from the list.

6. If you complete the settings, please click on “Apply” for changes to take effect.

WDS Mode

The feature lets you extend the range of your network without having to use cables to link the

Access Point, meaning that you can link wirelessly the Access Points. To use WDS by

clicking the check box next to “Enable WDS Mode”. There are four modes in which an

access point can be configured. Select the desired mode for your environment.

z Wireless Point-to-Point Bridge

z Wireless Point to Multi-Point Bridge

z Repeater with Wireless Client Association

z Enable Smart WDS