User's Manual

6
2-3 Mechanical Description
Front Panel
The front panel provides LED’s for device status. Refer to the following table for the meaning
of each feature.
LED STATUS Description
Off 802.11 a/b/g SMB Wireless Access Point is off.
PWR
On 802.11 a/b/g SMB Wireless Access Point is in service.
Off Indicates that leaving boot-code mode.
On Indicates that entering boot-code mode.
TEST
Blinking
1. Reset button is pressed around 3 seconds (slow blinking).
2. Reset button is pressed after 3 seconds (fast blinking).
3. While you upgrade firmware or reset to factory default, the
TEST LED is blinking. After firmware is upgraded or reset to
factory default, the Access Point will reboot automatically.
Off 10 Mbps Ethernet link is detected but no activity.
LAN
(100)
On 100Mbps Fast Ethernet link is detected but no activity.
LAN
(LINK/ACT)
Blinking Indicates that Data processing. (Frequency depends on traffic)
Off Indicates no 802.11g/b wireless links.
On Wireless LAN is in service but no activity.
802.11g
WLAN
Blinking Indicates the device is linking or active data through wireless links.
Off Indicates no 802.11a wireless links.
On Wireless LAN is in service but no activity.
802.11a
WLAN
Blinking Indicates the device is linking or active data through wireless links.