User's Manual

Rear Panel

To know the rear panel features, please refer to the following table for the meaning of each

feature.

Power

Socket

(DC 12v)

Connect the DV 12V/1.2A power supply. ONLY use the power adapter

supplied with the 802.11 a/b/g SMB Wireless Access Point. Otherwise,

the product may be damaged.

Reset

Simply press the reset button and keep pressing it for around 5

seconds. The 802.11 a/b/g SMB Wireless Access Point will be restored

to factory default settings.

LAN/POE

Use the Ethernet RJ-45 port to connect to the 10/100Mbps Ethernet

network and Ethernet through a device such as a hub, switch, or router.

Primary

Here you can combine the antenna (5GHz band) with the 802.11 a/b/g

SMB Wireless Access Point to wirelessly connect to the 802.11a

networks. In order to improve the RF signal radiation of your antenna,

proper antenna placement is necessary.

Secondary

Here you can combine the antenna (2.4GHz band) with the 802.11

a/b/g SMB Wireless Access Point to wirelessly connect to the

802.11g/b networks. In order to improve the RF signal radiation of

your antenna, proper antenna placement is necessary.

Note: Each of these two antennas must be connected to its corresponding connector to

receive RF. Otherwise it will fail.