User's Manual

1. Introduction
IEEE802.11 a/b/g/n dual band 2x2 Wireless Network Mini PCI Adapter is the perfect solution for your
wireless network applications based on the IEEE 802.11n standard offering a data rate of up to
300Mbps in a wireless LAN environment.
AN-622 can easily integrate into a wide range of devices such as Access Point, Router, ATUR, Printer
Server series, IP Camera series and Internet Video Server, etc. The new MIMO wireless miniPCI offers
dramatic performance improvement and backward compatible over standard 802.11a/b/g wireless
devices. It provides high-speed wireless connection with data rate up to 300Mbps (two streams) and
connects to farther distance.
2. Features
.Dual band 802.11 a/b/g/n support 2Tx/2Rx to enable data rate up to 300Mbps link rate for 40MHz
channel, six times the throughput of 802.11a and 802.11g.
.802.11n Draft 2.0 compliant Wi-Fi solution. Fully compatible with 802.11a/b/g legacy devices.
.Compatible with Wi-Fi Wireless Products and Services
.High system integration drives.
.Two UF-L Connectors for External Antenna
.Features WEP, WPA-AES hardware-based and TKIP security capabilities.
3. Hardware Installation
The following sections in this chapter describe how to install AN-622 Module
3.1. Installation Overview
AN-622 wireless module is design for Access Point, Router, ATU-R, Printer Server series, IP Camera
series and Internet Video Server only.
3.2. Safety Recommendations
The safety guidelines are as follows:
λ Keep the board area clear and dust-free before, during, and after installation.
λ Keep tools away from walk areas where you and others could fall over them.
λ Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains, that could get
caught in the board.
λ Wear safety glasses if you are working under any conditions that might be hazardous to
your eyes.
λ Do not perform any action that creates a potential hazard to
people or makes the equipment unsafe.
λ Never attempt to lift an object that is too heavy for one person to handle.
3.3. Maintaining Safety with Electricity
Warning: Before working on a board or working near power supplies, unplug the power cord on AC units;
on DC units, disconnect the power at the circuit breaker.
Follow these guidelines when working on equipment powered by electricity:
λ Do not work alone if potentially hazardous conditions exist anywhere in
your work space.
λ Never assume that power is disconnected from a circuit; always
check the circuit.