User's Manual

10
 Connect the Power Cable
Connect the power adapter to the power socket on the 802.11g SMB Wireless Access
Point, and plug the other end of the power into an electrical outlet.
Warning: We cannot assume the responsibility for the damage from using with the other
power adapter supplier.
 Configure the wireless device settings
To access the 802.11g SMB Wireless Access Point, wireless device needs to configure
the 802.11b or 802.11g Wireless Adapter to use the 802.11g SMB Wireless Access Point
factory default settings as follows:
SSID: My Network
Channel: 1
WEP: Disable
For all listing of factory defaults, please refer to “802.11g SMB Wireless Access Point
Default Factory Settings” on page 12.
 Verify wireless connectivity to the network
Using a computer with an 802.11b or 802.11g wireless adapter, browse internet or check
file access on the network. If everything is functioning properly, then you have
successfully installed the 802.11g SMB Wireless Access Point.
2-5 Safety Notification
Your Wireless AP should be placed in a safe and secure location. To ensure proper operation,
please keep the unit away from water and other damaging elements.
 Please read the user manual thoroughly before you install the device.
 This device should only be repaired by authorized and qualified personnel.
 Please do not try to open or repair the device yourself.
 Do not place the device in a damp or humid location, i.e. a bathroom.
 Please do not expose the device to direct sunlight or other heat sources. The housing and
electronic components may be damaged by direct sunlight or heat sources.