User's Manual

21
Configure a Point-to-Point Wireless Bridge (P2P)
To activate the Point-to-Point Bridge mode please do the following:
1. Configure WDS mode for both Access Point:
 Configure both AP1 on LAN Segment A and AP2 on LAN Segment B in Point-to-Point
Bridge mode.
 AP1 must have AP2’s Mac address and enter it in the Remote MAC Address field.
 AP2 must have AP1’s Mac address and enter it in the Remote MAC Address field.
2. Enable Access Point function:
 Verify that AP1 and AP2 are both configured in the same LAN network address range
as wireless clients with which associated.
 Set the same channel for both of your WDS-compliant Access Points.
3. Then, wireless clients can communicate with other wireless clients that are located in
different LAN Segments.
4. After you complete the setting, please click the Apply button for changes to take effect.