User's Manual

Configure a Repeater Wireless Bridge

To activate the Point-to-Point Bridge mode please do the following:

1. Configure WDS mode for both Access Point:

 Configure AP1 on LAN Segment A in Repeater mode with the Remote MAC Address

of AP2.

 Configure AP2 on LAN Segment B in Repeater mode with the Remote MAC Address

of AP1 and AP3.

 Configure AP3 on LAN Segment C in Repeater mode with the Remote MAC Address

of AP2.

2. The device under the repeater mode also can be an AP mode. It means wireless clients

also can associate it.

 Verify that all access points are configured in Repeater Bridge mode.

 All the access points’ IP Address must be set in the same network.

 Make sure that Mode, SSID, Channel and encryption settings are set the same for all

of your WDS-compliant Access Points.

3. Then, wireless clients can communicate with other wireless clients that are located in

different LAN Segments.

4. After you complete the setting, please click the Apply button for changes to take effect.

Note: Under Repeater Bridge mode, you can extend this repeater bridge by adding additional

802.11g SMB Wireless Access Points for each additional LAN Segment.