User's Manual

Chapter 4 Advance Settings Page 39
Input the IP address of the PPTP server that your ISP provided.
User Name and Password:
Input the user name and password that your ISP assigned to you to login PPTP server. I
Connection Type:
You can select the connection type from pull-down list. There are Continuous, Connect on
Demand and Manual three types to select. Continuous connection type means to setup the
connection through PPTP protocol whenever this Wireless Broadband Router is powered on.
Connect on Demand connection type means to setup the connection through PPTP protocol
whenever you send the data packets out through the WAN interface; there are a watchdog
implemented to close the PPTP connection while there are no data sent out longer than the
idle time set. Manual connection type means to setup the connection through the PPTP
protocol by clicking the Connect button manually, and clicking the Disconnect button
manually.
Idle Time:
You may enter the number of time when connection type set to Connect on Demand.
MTU Size:
Change the MTU size that your ISP provided. The default value is 1460 and range is 1400 to
1460 bytes.
Request MPPE Encryption:
You can select the check box to enable MPPE Encryption (Microsoft Point to Point Encryption)
for your network.
Request MPPC Compression:
You can select the check box to enable MPPC Compression (Microsoft Point to Point
Compression) for your network.
Attain DNS Automatically:
You can select this option to get DNS address from the DHCP server.
Set DNS Manually:
You can select Set DNS Manually, and input at most three DNS servers in the below field.
DNS 1/2/3:
Enter Domain Name Server IP address that your ISP provided.
Clone MAC Address
Input the MAC Address that wants to be cloned.
Enable uPNP:
You can select it according to your request.
Enable IGMP Proxy
You can select it according to your request.