User's Manual

Chapter 4 Advance Settings Page 46
Port Forwarding
Entries in this table allow you to automatically redirect common network services to a specific
machine behind the NAT firewall. These settings are only necessary if you wish to host some sort of
server like a web server or mail server on the private local network behind your Gateway's NAT
firewall.
Figure 39 Port Forwarding Settings
Select Enable Port Forwarding to activate this setting. Clear this check box to disable it.
Select Protocol from the drop-down list box. You can assign the filter protocol to TCP, UDP or both.
After that you may enter a range of port numbers to be forwarded, and the local IP address of the
desired server. Click Apply Changes to save the settings. Click Reset to start configuring this part
of the screen again.